Deez Tungsten Carbide Nozzle

Deez Tungsten Carbide Nozzle



A cast then fully machined, fully Tungsten Carbide, high flow Nozzle with backpressure reducing and flow boosting geometry.

This product is a collaboration between Noctus3D, Printyplease, West3D, and Alex. Please buy from your local vendor if you live in germany, UK or USA.

We’ve done our best to bring you the very best nozzle possible. High flow, abrasive printing is now possible and all without worrying about cost or quality

The pictures don’t do them justice. They are beautiful. We’ve kept our QC standards extremely high to make sure the threads, bore and nozzle tip are as precise and pretty as possible. You won’t need to be tapping your heater block or sanding the back end of these, just screw in (hot tighten please) and start printing!

Featuring a * style bore, which increases surface area in contact with the plastic, and reduces the distance to the nozzle itself from the centre of the plastic, leading to higher melt capacity.

  • .4mm, .5mm orifice, spacers also available to use them with Volcano heatblocks.
  • V6 compatible. Will work in a Mk8 Creality machine I guess, but will be a bit long, so careful with your Z height.
  • 7mm hex to be *incompatible* with the mosquito magnum+ heat shield.

0.5mm is preferred by some for hardened nozzles as some filaments may have say, carbon fibres longer than 0.4mm that will clog a 0.4mm. Obviously being TC, you can torch them clean.

On backorder until mid December

Additional information

Weight 0.05 kg
Dimensions 1 × 1 × 1 cm

0.4mm, 0.5mm